Since X-ray and gamma radiation are not detectable by the human senses and the resulting damage to the body is not immediately apparent, a variety of safety controls are used to limit exposure. The two basic types of radiation safety controls used to provide
a safe working environment are engineered and administrative controls. Engineered controls include shielding, interlocks, alarms,
warning signals, and material containment. Administrative controls include postings, procedures, dosimetry, and training.
Engineered controls such as shielding and door interlocks are used to contain
the radiation in a cabinet or a "radiation vault." Fixed shielding materials
are commonly high density concrete and/or
lead. Door interlocks are used to immediately cut the power to X-ray generating equipment if a door is accidentally opened when X-rays are being produced. Warning lights are used to alert workers and the public that radiation is being used. Sensors and warning alarms are often used to signal that a predetermined
amount of radiation is present. Safety controls should never be tampered with or bypassed.
When portable radiography is performed, it is most often not practical to place alarms or warning lights in the exposure area. Ropes and signs are used to block the entrance to radiation areas and to alert the public to the presence of radiation. Occasionally, radiographers will use battery operated flashing lights to alert the public to the presence of radiation. Portable or temporary shielding devices may
be fabricated from materials or equipment located in the area
of the inspection. Sheets of steel, steel beams, or
other equipment may be used for temporary shielding. It is the
responsibility of the radiographer to know and understand the
absorption value of various materials. More information on absorption values and material properties can be found
in the radiography section of this site.
As mentioned above, administrative controls supplement the engineered controls. These controls include postings, procedures, dosimetry, and training. It is commonly required that all areas containing X-ray producing equipment or radioactive materials have signs posted bearing the radiation symbol and a notice explaining the dangers of radiation. Normal operating procedures and emergency procedures must also be prepared and followed. In the US, federal law requires that any individual who is likely to receive more than 10% of any annual occupational dose limit be monitored for radiation exposure. This monitoring is accomplished with the use of dosimeters, which are discussed in the radiation safety equipment section of this material. Proper training with accompanying documentation is also a very important administrative control.